Seat Ateca 2017 Workshop Manual page 403

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
9 - Rear silencer (left-side)
❑ Disconnecting exhaust pipes/silencers
❑ Stress-free alignment of exhaust system
1.1.4 Assembly overview - silencer, Cupra ST
Carbon Fiber Kit
Original equipment as single assembly together with rear silenc‐
er; to be renewed individually in event of repair
1 - Middle silencer
❑ Separating exhaust
pipes from silencers
⇒ page 411
❑ Aligning exhaust sys‐
tem free of tension
⇒ page 411 .
2 - Retaining rings
❑ Renew if damaged
3 - Rear silencer
❑ Original equipment as
single assembly togeth‐
er with rear silencer; to
be renewed individually
in event of repair
❑ Disconnecting exhaust
pipes/silencers
⇒ page 408
❑ Stress-free alignment of
exhaust system
⇒ page 411
4 - Rear silencer
❑ Original equipment as
single assembly togeth‐
er with rear silencer; to
be renewed individually
in event of repair
❑ Separating exhaust
pipes from silencers
⇒ page 410
❑ Aligning exhaust sys‐
tem free of tension
⇒ page 411 .
5 - Support plate
❑ Renew if damaged.
❑ 2x
6 - Bolts
❑ 3x
❑ 20 Nm.
7 - Nuts
❑ 30 Nm.
8 - Clamping sleeve
❑ Installation position
❑ Stress-free alignment of exhaust system
⇒ page 408
⇒ page 411
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 397 .
⇒ page 411
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
1. Exhaust pipes/silencers
395