Seat Ateca 2017 Workshop Manual page 135

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Install cover immediately and tighten bolts.
Note
Do not tighten bolts -1- and -4- with turning further angle until after
the vibration damper has been installed. The bolts must be un‐
screwed again for installing the vibration damper. Observe differ‐
ences in torque for steel and aluminium bolts!
Stage Steel bolts
1. -1 - 8-
2. -1 - 8-
Stage Aluminium bolts Specified torque/turning further angle
1. -1 - 8-
2. -1 - 8-
Continued for all vehicles
– Fit the vibration damper
– Install valve for oil pressure control - N428-
– Install poly V-belt tensioner
– Fit poly V-belt
– Install front right wheel housing liner ⇒ General body repairs,
exterior; Rep. gr. 66 ; Wheel housing liners; Assembly over‐
view - Front wheel housing liner .
– Replenish engine oil and check oil level ⇒ Maintenance ;
Booklet 501 ; Engine oil: Draining; Renewing oil filter and re‐
plenishing engine oil .
Specified torques
♦ ⇒ "2.1 Assembly overview - timing chain cover", page 119
♦ ⇒ Fig. ""Engine support - Tightening torque and sequence"" ,
page 70
♦ ⇒ "2.1 Installation overview - assembly mountings", page 44
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Torque specification and turning fur‐
ther angle for steel bolts
8 Nm
45°
for aluminium bolts
4 Nm
45°
⇒ page 61 .
⇒ page 67
⇒ page 60 .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
⇒ page 231 .
.
EA 888 III. Gen) - Edition 10.2018
2. Timing chain cover
127