Seat Ateca 2017 Workshop Manual page 205

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Intake side
Exhaust side
Note
If the valve cones were extracted from the assembly cartridge,
♦
they must be placed on the base - VAS 5161/18- .
Press assembly cartridge -VAS 5161/8- onto insertion device
♦
from above and pick up valve cotters.
– Use pressure fork - VAS 5161/8- to press down assembly car‐
tridge - VAS 5161/2- , then turn knurled screw of assembly
cartridge back and forth while pulling upwards.
– Release pressure fork - VAS 5161/2- with knurled screw in
pulled position.
– Detach removal and installation device for valve cotters - VAS
5161- .
Further assembly is basically the reverse of the dismantling se‐
quence. In the process, note the following:
– Install camshafts ⇒ page 158
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
197
4. Valve gear