Seat Ateca 2017 Workshop Manual page 257

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
♦ Assembly aid - T10118-
Schematic overview of coolant flushing and filling device - VAS
531 007- :
1 - Container with distilled wa‐
ter
❑ Fill with 30 l of distilled
water
2 - Container with coolant
❑ Fill with 30 l of coolant
❑ Frost protection down to
approx. -36 °C
3 - Empty container
❑ For used coolant
4 - Empty container
❑ For used coolant
5 - Extraction hose
❑ Comes from connection
2 on sight glass
6 - Window
❑ When opaque, clean
sight class with a nylon
brush
7 - Pump
❑ Cut-out pressure
approx. 1.5 bar
8 - Valve block
❑ With pressure gauge
and shut-off taps
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
9 - Drain hose
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
❑ Connected to valve
block for releasing pres‐
sure
10 - Flushing hose
❑ Connected to breather
hose of coolant expansion tank for flushing
❑ Comes from connection 1 on sight glass
❑ Seal with plugs when not in use
11 - Plug
12 - Hose clamps
❑ Qty. 4
13 - Cleaning adapter
❑ Approx. 15 cm in length
❑ For cleaning coolant flushing and filling device after flushing
❑ Connected between valve block and flushing hose
14 - Extraction adapter
❑ Approx. 100 cm in length
❑ Connected to suction hose
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
⇒ Item 5 (page 249) (5) for extracting coolant
EA 888 III. Gen) - Edition 10.2018
⇒ Item 10 (page 249) (10)
1. Cooling system/coolant
249