Seat Ateca 2017 Workshop Manual page 225

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
♦ Drip tray for workshop hoist - VAS 6208-
Removing
CAUTION
On a warm engine, the cooling system is under high pressure.
Danger of scalding by steam and hot coolant.
Risk of scalding to skin and body parts.
– Wear protection gloves.
– Wear safety goggles.
– Reduce excess pressure by covering cap of coolant expan‐
sion tank with cloths and opening it carefully.
– Drain coolant ⇒ page 239
– Remove bracket for ancillaries
– Unscrew bolts -4 and 5- and remove engine oil cooler -3- to‐
gether with seal -2-.
Fitting
Install in the reverse order of removal, observing the following:
Note
Renew gaskets and seals.
♦
Secure all hose connections with the correct type of hose clips
♦
(same as original equipment) ⇒ Electronic parts catalogue
(ETKA) .
– Install engine oil cooler -3- with new seal -2-.
– Install bracket for ancillaries
– Replenish coolant ⇒ page 240
– Replenish engine oil and check oil level ⇒ Maintenance ;
Booklet 501 ; Engine oil: Draining; Renewing oil filter and re‐
plenishing engine oil .
Specified torques
♦ ⇒ "2.1 Assembly overview - engine oil cooler", page 216
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
.
⇒ page 67 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 67 .
.
EA 888 III. Gen) - Edition 10.2018
2. Engine oil radiator
217