Seat Ateca 2017 Workshop Manual page 461

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Release connectors and unplug all connectors from the igni‐
tion coils at the same time.
– Insert puller - T10530- into hole -1- in ignition coil.
– Turn knurled nut -2- clockwise until puller is secured in place.
– Working vertically upwards, carefully pull ignition coil out with
puller - T10530- .
Installing
Install in reverse order of removal, observing the following:
– Press ignition coils onto spark plugs by hand evenly (do not
use tools).
– Tighten ignition coils.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Specified torques respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ ⇒ "1.1 Assembly overview - ignition system", page 451
Component
Ignition coil earth wire
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
Tightening torque
9 Nm.
EA 888 III. Gen) - Edition 10.2018
1. Ignition system
453