Remove And Install Intake Manifold Sender Gx9 - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Unscrew fuel pressure sender for low pressure - G410- -1-
from adapter -2-.
Fitting
– Fit new O-ring -arrow-.
– Screw adapter -2- onto fuel pressure sender for low pressure
- G410- -1-.
– Carefully slide fuel pressure sender for low pressure - G410-
-1- into fuel rail as far as it will go.
– Insert securing clip -1- into groove.
– Connect the electric connector -2-.
Specified torques
♦ ⇒ "2.1 Assembly overview - fuel rail with injectors", page 343
5.5 Remove and install intake manifold
sender - GX9-
The intake manifold sender - GX9- consists of intake air temper‐
ature sender - G42- and intake manifold pressure sender - G71- .
Removing
– Remove engine cover panel
– Unplug electrical connector -2-.
– Unscrew the bolt -1-.
– Release fasteners -arrows-, and pull intake manifold sender -
GX9- off intake manifold.
Fitting
Installation is in the reverse sequence of removal.
Specified torques
♦ ⇒ "4.1 Exploded view - intake manifold", page 358
374
Rep. gr.24 - Mixture preparation - injection
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 57 .