Installing Radiators And Condensers; Vacuum System: Checking - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
connected. Where necessary, make sketches or take photo‐
graphs.
♦ To prevent damaging pipes, hoses and wiring, ensure suffi‐
cient clearance from all moving or hot components in engine
compartment (little space in engine compartment).
3.5

Installing radiators and condensers

Even if installed correctly, the radiator, the condenser and the
charge air cooler may have small dents in their fins. This does not
mean that the components are damaged. It is not permissible to
renew radiators, charge air coolers or condensers only because
of such minor dents.
3.6

Vacuum system: checking

Special tools and workshop equipment required
♦ Hand vacuum pump - VAS 6213-
Operation process
– Check all vacuum lines in the complete vacuum system for:
♦ Cracks
♦ Traces of animal bites
♦ Kinked or crushed lines
♦ Lines porous or leaking
– Check vacuum line to solenoid valve and from solenoid valve
to corresponding component.
– If a fault is stored in the event memory, check all vacuum lines
leading to the corresponding component, and also check the
remaining vacuum lines leading to other components.
– If it is not possible to build up pressure with the hand vacuum
pump - VAS 6213- or if the pressure drops again immediately,
check the hand vacuum pump and connecting hoses for leaks.
10
Rep. gr.00 - Technical data
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.