Removing And Installing Coolant Pipes (Top) - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Note
Place a cloth under coolant pipe to catch escaping coolant.
– Clamp off coolant hoses -1, 2- with hose clamps up to 25 mm
- 3094- .
– Release hose clips and detach coolant hoses.
– Unscrew bolts -arrows- and remove coolant pipe (front).
Fitting
Install in the reverse order of removal, observing the following:
Note
Secure all hose connections with the correct type of hose clips
(same as original equipment) ⇒ Electronic parts catalogue (ET‐
KA) .
– Check coolant level
Specified torques
♦ ⇒ "3.1 Exploded view - coolant pipes", page 287
3.3 Removing and installing coolant pipes
(top)
Special tools and workshop equipment required
♦ Hose clamps, up to Ø 25 mm - 3094-
♦ Hose clip pliers - VAS 6362-
⇒ page 244 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
289
3. Coolant pipes