Seat Ateca 2017 Workshop Manual page 415

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Unscrew bolt -1- from the body.
– Unfasten clamps -arrows-.
– Remove silencer -2-.
Fitting
Install in the reverse order of removal, observing the following:
– Align exhaust system free of stress
Specified torques
♦ ⇒ "1.1.2 Assembly overview - silencers, engine codes CJSA ,
CJSB, Leon SC, 5-door", page 393
1.4.3 Removing and installing front silencer,
engine codes CJXA, CJXE
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Note
In the original factory equipment, this is a single piece with the
♦
centre silencer. Can be renewed individually for repair purpo‐
ses.
The connecting pipe -A- can be cut through at the separating
♦
points in order to renew the rear silencers separately
⇒ page 408 .
Removing
– Remove the rear tunnel bridge -2-.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
⇒ page 411 .
EA 888 III. Gen) - Edition 10.2018
1. Exhaust pipes/silencers
407