Removing And Installing Cylinder Head - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
1.2

Removing and installing cylinder head

Special tools and workshop equipment required
♦ Sealing cap set for engine - VAS 6122-
♦ Special wrench (Polydrive) - T10070-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Removing
Note
Before the cylinder head is removed, the engine support and
♦
engine mounting must be reinstalled temporarily, because the
eyes of the support bracket are secured to the cylinder head.
Fit the cable ties in the original position when installing.
♦
Seal open channels of intake and exhaust system with suitable
♦
plugs from engine sealing cap set - VAS 6122- .
Cover the openings in the gearbox with a cloth to avoid letting
♦
coolant in the clutch housing.
– Drain coolant ⇒ page 239
– Remove air filter housing
– Remove camshafts
– Remove catalytic converter
108
Rep. gr.15 - Cylinder head, valve gear
.
⇒ page 356 .
⇒ page 158 .
⇒ page 420 .