Checking Oil Pressure - Seat Ateca 2017 Workshop Manual

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
– Loosen hose clip -arrow-, and remove charge air hose -1-
downwards, together with air pipe.
– Unplug electrical connector -1- on stage 3 oil pressure switch
- F447- .
– Remove bolts -arrows- and detach toothed belt cover.
Note
Use a cloth to collect the leaking engine oil.
– Remove stage 3 oil pressure switch - F447- -item 2- with 24
mm articulated wrench - T40175- .
Fitting
Install in the reverse order of removal, observing the following:
Note
Renew seal.
♦
Screw new stage 3 oil pressure switch - F447- immediately
♦
into bore to avoid loss of oil.
– check oil level⇒ Maintenance ; Booklet 501 .
Specified torques
♦ ⇒ "4.2 Exploded view - oil pressure switches/oil pressure con‐
trol", page 222
♦ ⇒ "3.1 Exploded view - air cleaner housing", page 355
♦ Assembly overview - noise insulation ⇒ General body repairs,
exterior; Rep. gr. 66 ; Noise insulation; Assembly overview -
noise insulation .
4.7

Checking oil pressure

⇒ "4.7.1 Checking engine oil pressure", page 227
⇒ "4.7.2 Checking oil pressure and oil spray jets", page 229
4.7.1 Checking engine oil pressure
Special tools and workshop equipment required
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
4. Oil filter/oil pressure switches
227