Suction Hose; Exploded View - Intake Manifold - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
4

Suction hose

⇒ "4.1 Exploded view - intake manifold", page 358
⇒ "4.2 Removing and installing intake manifold", page 359
⇒ "4.3 Throttle valve control unit GX3 : removing and fitting", page
365
⇒ "4.4 Cleaning throttle valve module ", page 367
4.1

Exploded view - intake manifold

1 - Bolt
❑ 20 Nm
2 - Support for intake manifold
3 - Nut
❑ 10 Nm
4 - Bonded rubber bush
❑ 5 Nm
5 - Bolt
❑ 7 Nm
6 - Throttle valve control mech‐
anism - GX3-
❑ With activation of the
throttle valve control for
electric accelerator con‐
trol - G186- , angle
senders 1 for throttle
valve control with elec‐
tric accelerator control -
G187- and angle sender
2 for throttle valve con‐
trol with electric acceler‐
ator control - G188-
❑ After removing, instal‐
ling or renewing throttle
valve module - GX3- it
must be re-adapted to
engine control unit -
J623- using ⇒ Vehicle
diagnostic tester.
7 - Seal
❑ Renew after removing
8 - Suction hose
❑ Removing and fitting
⇒ page 359
9 - Intake manifold flap potentiometer - G336-
10 - Ball head stud
❑ For engine cover panel
❑ 5 Nm
11 - O-ring
❑ Renew after removing
12 - Bolt
❑ 2.5 Nm
358
Rep. gr.24 - Mixture preparation - injection
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.