Removing And Installing Flywheel - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
Install intermediate plate.
– Fit intermediate plate on sealing flange and push onto dowel
sleeves -arrows-.
Sealing flange at gearbox end - tightening sequence
– Tighten bolts -1 to 8- in the specified sequence.
Stage Bolts
1. -1 - 8-
2. -1 - 8-
2.2

Removing and installing flywheel

Special tools and workshop equipment required
♦ Counterhold - 3067-
Removing
• Gearbox removed.
Note
Remove bolts -B- using normal hand tools (do not use pneu‐
♦
matic wrench or impact driver, etc.).
When removing the bolts, make sure that the bolt heads do
♦
not come into contact with the flywheel.
Rotate the flywheel -A- so that the bolts -B- align centrally with
♦
the holes -arrows-.
74
Rep. gr.13 - Crankshaft group
Specified torque/turning further angle
Screw in by hand as far as stop
9 Nm
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.