Seat Ateca 2017 Workshop Manual page 411

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
Removing
– Disconnect the electrical connector -1- from exhaust flap con‐
trol unit. - J883-
– Loosen clamp -arrow- and push towards rear.
CAUTION
Risk of accident caused by high weight of silencers.
– Seek help from a second a mechanic for the following work.
– Unscrew bolts -2- from the body. Remove silencer -3-.
Fitting
Install in the reverse order of removal, observing the following:
– Align exhaust system free of stress
Specified torques
♦ ⇒ "1.1.5 Assembly overview - silencers, engine codes CJXA,
CJXE, CJXH, Leon SC, 5-door", page 396
♦ ⇒ Fig. "" Exhaust flap control unit -J883- - tightening torque"" ,
page 397
1.2.4 Remove and install silencer, Leon ST,
Cupra ST Carbon Fiber KIt
Note
In the original factory equipment, this is a single piece with the
♦
centre silencer. Can be renewed individually for repair purpo‐
ses.
The connecting pipe -A- can be cut through at the separating
♦
points in order to renew the rear silencers separately
⇒ page 408 .
Removing
– Loosen clamping sleeve -4-.
– Unscrew bolt -5- from the body.
– Detach mounting -2- from the silencer.
CAUTION
Risk of accident caused by high weight of silencers.
– Seek help from a second a mechanic for the following work.
– Unscrew bolts -1- from the body. Remove silencer -3-.
Installing
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
Install in the reverse order of removal, observing the following:
– Align exhaust system free of stress
Specified torques
♦ ⇒ "1.1.4 Assembly overview - silencer, Cupra ST Carbon Fiber
Kit", page 395
⇒ page 411
respect to the correctness of information in this document. Copyright by SEAT S.A.
⇒ page 411
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
EA 888 III. Gen) - Edition 10.2018
.
.
1. Exhaust pipes/silencers
403