Seat Ateca 2017 Workshop Manual page 343

4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
D - Clutch position sender - G476-
❑ Only fitted on vehicles with manual gearbox
❑ Location ⇒ page 336
E - Accelerator pedal module - GX2-
❑ comprising:
Accelerator position sender - G79-
Sender 2 for the accelerator pedal position - G185-
❑ Location ⇒ Fig. "" Accelerator pedal module -GX2- "" , page 335
❑ On the accelerator pedal (both senders are located in the housing)
❑ Removing and installing ⇒ Rep. gr. 20 ; Accelerator mechanism; Assembly overview - accelerator pedal
module .
F - Fan control unit - J293-
❑ Incorporated in radiator fan
G - Stage 3 oil pressure switch - F447-
❑ Location ⇒ page 338
❑ Removing, installing and testing
H - Left electrohydraulic engine mounting solenoid valve - N144- and right electrohydraulic engine mounting
solenoid valve - N145-
❑ Not installed in all vehicles (depends on gearbox type)
Accelerator pedal module - GX2-
2 - Electrical connector for accelerator pedal module
Note
The accelerator position sender - G79- and accelerator position
sender 2- - G185- are integrated in the accelerator pedal module
and cannot be renewed individually.
Installation location of the brake pedal switch - F- / brake pedal
switch - F63- and of the vacuum sensor - G608-
♦ On brake servo in engine compartment.
1 - Brake light switch - F- / Brake pedal switch - F63-
2 - Vacuum sender - G608-
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
⇒ page 226
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
EA 888 III. Gen) - Edition 10.2018
1. Injection system
335