Air Filter Housing: Removing And Fitting - Seat Ateca 2017 Workshop Manual

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
3.2

Air filter housing: removing and fitting

Removing
Remove air filter housing
For reasons of space, remove the air filter housing together with
the intake hose ⇒ page 356
Remove air filter housing.
– Pull off connector -2- for air mass measurement module -
GX35- .
– Open hose clip -3-, and remove air hose.
– Pull off vacuum hose.
– Pull air filter housing -1- upwards off ball head pins -4-.
– Turn air filter housing -2- in -direction of arrow- out of front air
duct -c-.
For reasons of space, remove air filter housing together with air
intake hose.
– Disconnect vacuum hose -1-.
– Loosen the hose clip -2-, remove the air intake hose.
– Remove and pull off air filter housing -3- upwards from the
rubber mountings.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
356
Rep. gr.24 - Mixture preparation - injection
⇒ page 356 .
.