Seat Ateca 2017 Workshop Manual page 444

Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
– Unscrew the Lambda probe -1- using tool from Lambda probe
open ring spanner set - 3337/7- .
– Unscrew bolt -2- and slide clamp onto the turbocharger.
– Unscrew nuts -1 and 3-.
Note
For illustration purposes, the installation position is shown with
♦
the engine removed.
♦ Ignore -item 4-.
Note
Risk of damage to flexible joint
♦
Do not allow the decoupling element to kink by more than 10°.
♦
Do not damage wire mesh on decoupling element.
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
– Remove middle underbody cladding ⇒ General body repairs,
exterior; Rep. gr. 66 ; Underbody cladding; Removing and
installing underbody cladding .
– Remove right wheel.
– Unscrew screws -arrows- with the bit - 3247- and remove heat
shield -1-.
436
Rep. gr.26 - Exhaust system
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.