Final Inspection; Seats; Seat Belt; Battery Electrolyte Level Check - Suzuki Baleno Manual

FINAL INSPECTION

WARNING:
When carrying out road tests, select a safe
place where no man or no running vehicle is
seen so as to prevent any accident.

Seats

Check that seat slides smoothly and locks securely at
any position. Also check that reclining mechanism of
front seat back allows it to be locked at any angle.

Seat Belt

Inspect belt system including webbing, buckles, latch
plates, retractors and anchors for damage or wear.
If "REPLACE BELT" label on belt is visible, replace
belt.
Check that seat belt is securely locked.

Battery Electrolyte Level Check

Check that the electrolyte level of all battery cells is be-
tween the upper and lower level lines on the case. If
battery is equipped with built-in indicator, check bat-
tery condition by the indicator.
Accelerator Pedal Operation
Check that pedal operates smoothly without getting
caught or interfered by and other part.
Engine Start
Check engine start for readiness.
WARNING:
Before performing the following check, be
sure to have enough room around the vehicle.
Then, firmly apply both the parking brake and
the regular brakes. Do not use the accelerator
pedal. If the engine starts, be ready to turn off
the ignition promptly. Take these precautions
because the car could move without warning
and possibly cause personal injury or proper-
ty damage.
MAINTENANCE AND LUBRICATION 0B-19
On automatic transmission vehicles, try to start the en-
gine in each gear. The starter should crank only in "P"
(Park) or "N" (Neutral).
On manual transmission vehicles, place the shift lever
in "Neutral," depress clutch fully and try to start.
Exhaust System Check
Check for leakage, cracks or loose supports.
Clutch (For Manual transmission)
Check for the following.
D Clutch is completely released when depressing
clutch pedal,
D No slipping clutch occurs when releasing pedal and
accelerating,
D Clutch itself is free from any abnormal condition.
Gearshift or Select Lever (Transmission)
Check gear shift or select lever for smooth shifting to
all positions and for good performance of transmission
in any position.
With automatic transmission equipped vehicle, also
check that shift indicator indicates properly according
to which position select lever is shifted to.
CAUTION:
With automatic transmission equipped ve-
hicle, make sure that vehicle is at complete
stop when shifting select lever to "P" range
position and release all brakes.
Brake
[Foot brake]
Check the following;
D that brake pedal has proper travel,
D that brake works properly,
D that it is free from noise,
D that vehicle does not pull to one side when brake is
applied,
D and that brake does not drag.