Table of Contents
Advertisement
2B-15 Front Suspension:
Front Suspension Frame, Stabilizer Bar and/or Bushings Components
A: View A
1. Stabilizer bar
2. Stabilizer bushing
3. Stabilizer mounting bracket
Front Suspension Frame, Stabilizer Bar and/or
Bushings Removal and Installation
WARNING
!
Do not touch exhaust system to avoid danger
of being burned when it is still hot.
Any service on exhaust system should be
performed when it is cool.
When removing front suspension frame, be
sure to apply some supporting equipment
(such as mission jack) under it at well-
balanced position in the center section so as
to prevent from its drop.
Removal
CAUTION
!
Be sure to set front wheels (tires) in straight
direction and remove ignition key from key
cylinder before performing the following
steps; otherwise, contact coil of air bag
system may get damaged.
4. Stabilizer bar mounting
bracket bolt
5. Stabilizer joint
6. Stabilizer joint nut
7. Suspension control arm
S7RS0B2206015
8. Suspension control arm mounting bolt
9. Front suspension frame
10. Front suspension frame mounting bolt
: 23 N⋅m (2.3 kgf-m, 17.0 lb-ft)
1) Remove steering joint cover.
2) Make alignment marks (1) on pinion shaft (2) and
joint of steering lower shaft (3) for a guide during
reinstallation.
3) Loosen joint bolt (steering column side) (4) and
remove joint bolt (pinion shaft side) (5) and
disconnect steering lower shaft (3) from pinion shaft
(2).
5
1
S7RS0B2206014
I6RS0C220016-01
: 50 N⋅m (5.0 kgf-m, 36.5 lb-ft)
: 150 N⋅m (15.0 kgf-m, 108.5 lb-ft)
: 95 N⋅m (9.5 kgf-m, 68.0 lb-ft)
: Do not reuse.
3
4
3
5
2
I4RS0B630013-01
Hide quick links:
Advertisement
Chapters
Table of Contents
