Drive End Frame / Bearing Disassembly And Assembly; Generator Inspection - Suzuki GRAND VITARA 2005 Service Manual

1J-10 Charging System:
c) Remove pin from brush holder.
6) Install insulator (3).
7) Install rear end cover (2) to coil assembly and tighten
rear end cover nut (1) to specified torque.
2
8) Make sure that rotor turns smoothly.
Drive End Frame / Bearing Disassembly and
Assembly
Disassembly
1) Loosen screw (3) and then remove bearing retainer
(1) from drive end frame (2).
3
1
2) Push out drive end bearing by using hydraulic press
(1) and special tools.
Special tool
(A): 09913–75821
Assembly
1
3
I5JB0B1A0011-01
S5JB0B1A06010

Generator Inspection

2
Rotor
3
I5JB0B1A0019-01
1
A
I5JB0B1A0020-01
1) Press-fit drive end bearing by using special tools and
press (1).
Special tool
(A): 09913–76010
CAUTION
!
Be sure to use new bearing.
2) Install bearing retainer to drive end frame and tighten
screw.
1) Using an ohmmeter, check for continuity between
slip rings of rotor. If there is no continuity, replace the
rotor assembly.
2) Using an ohmmeter, check that there is no continuity
between slip ring and rotor. If there is continuity,
replace the rotor assembly.
3) Check slip rings for roughness or scoring. If rough or
scored, replace the rotor assembly.
1
A
I5JB0B1A0021-01
S5JB0B1A06005
IYSQ011A0042-01
IYSQ011A0043-01