Toyota Tundra 2005 Service - Repair - Maintenance page 2339

AUTOMATIC TRANSMISSION (A750E, A750F)
2.0 Kw:
1.6 Kw:
D13780
D13868
− AUTOMATIC TRANSMISSION UNIT (1GR−FE)
13. REMOVE STARTER
(a) Remove the nut and disconnect the starter wire and con-
nector.
Torque: 9.8 N·m (100 kgf·cm, 7 ft·lbf)
(b) Remove the 2 bolts and starter.
Torque: 37 N·m (377 kgf·cm, 27 ft·lbf)
D14126
14. REMOVE TORQUE CONVERTER CLUTCH MOUNT-
ING BOLT
(a) Remove the flywheel housing side cover.
(b) Turn the crankshaft to gain access and remove the 6 bolts
while holding the crankshaft pulley set bolt with a wrench.
Torque: 48 N·m (490 kgf·cm, 35 ft·lbf)
HINT:
At the time of installation, refer to the following:
First install the green colored bolt and then the remaining 5
D14127
bolts.
15. JACK UP TRANSMISSION SLIGHTLY
Securely support the transmission on a transmission jack.
Lift the transmission slightly from the crossmember.
16. REMOVE CROSSMEMBER
(a) Remove the 4 bolts of the engine rear mounting on the
crossmember.
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
(b) Remove the 4 nuts, bolts, washers and crossmember.
Torque: 72 N·m (734 kgf·cm, 53 ft·lbf)
D05190
AT−29