Toyota Celica 2005 Repair Manual page 2465

Snap Ring
R−Shape
Rotor
2005 CELICA (RM1131U)
AIR CONDITIONING
NOTICE:
The snap ring should be installed so that beveled side
faces up.
Compressor
N20013
3.
(a)
Shim
Pressure
Plate
AC0946
(b)
SST
AC0945
4.
(a)
(b)
(c)
Dial Indicator
N04963
If the clearance is not within the standard clearance, adjust the
clearance using shims to obtain the standard clearance.
− COMPRESSOR AND MAGNETIC CLUTCH
INSTALL PRESSURE PLATE
Install the shims to the pressure plate and install the pres-
sure plate on the rotor.
Using SST and a torque wrench, install the shaft bolt.
SST 07112−66040, 07112−76060
Torque: 13.2 N·m (135 kgf·cm, 9 ft·lbf)
INSPECT MAGNETIC CLUTCH CLEARANCE
Set the dial indicator to the pressure plate of the magnetic
clutch.
Connect the magnetic clutch lead wire to the positive (+)
terminal of the battery.
Check the clearance between the pressure plate and ro-
tor when connecting the negative (−) terminal to the bat-
tery.
Standard clearance:
0.45 ± 0.10 mm (0.018 ± 0.004 in.)
Shim thickness:
0.1 mm (0.004 in.)
0.3 mm (0.012 in.)
0.5 mm (0.020 in.)
2464
AC−41