Match Ip Vlan - Dell S4810 Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Usage
To access this command, enter the class-map command. After the class map is
Information
identified, you can configure the match criteria.
The match ip precedence command and the match ip dscp command are
mutually exclusive.
Up to eight precedence values can be matched in one match statement. For
example, to indicate the IP precedence values 0 1 2 3, enter either the match ip
precedence 0-3 or match ip precedence 0,1,2,3 command.
Related
class-map
Commands

match ip vlan

Uses a VLAN as the match criterion for an L3 class map.
S4810
Syntax
match ip vlan vlan-id
To remove VLAN as the match criterion, use the no match ip vlan vlan-id
command.
Parameters
vlan vlan-id
Defaults none
Command CONF-CLASS-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Quality of Service (QoS)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
NOTE: Only one of the IP precedence values must be a successful match
criterion, not all of the specified IP precedence values must match.
— identifies the class map.
Enter the keyword vlan and then the ID of the VLAN. The
range is from 1 to 4094.
Introduced on the S-Series and Z-Series.
1353