Renault Laguna III Manual page 2399

MECHANICAL COMPONENT CONTROLS
Clutch circuit: Removal - Refitting
TL4
a Lift the retaining clip (4) from the hydraulic clutch
control pipe on the master cylinder.
a Disconnect the hydraulic clutch control pipe (5) .
a Fit plugs into the openings.
a Gently remove the hydraulic clutch control pipe tak-
ing care not to damage anything.
REFITTING
I - REFITTING PREPARATION OPERATION
a Check the condition of the seals.
a The blanking cover caps must be removed when
connecting the adjacent parts.
II - REFITTING OPERATION FOR PART
CONCERNED
a Fit the hydraulic clutch control pipe taking care not to
damage anything.
a Connect the hydraulic clutch control pipe on the side
of the slave cylinder.
a Press the retaining clip of the hydraulic clutch control
pipe on the master cylinder.
a Connect the hydraulic clutch control pipe to the mas-
ter cylinder.
a Refit the retaining clip of the hydraulic clutch control
pipe on the master cylinder.
III - FINAL OPERATION.
a Bleed the hydraulic circuit (see 37A, Mechanical
component controls, Clutch circuit: Bleed, page
37A-47) .
LEFT-HAND DRIVE
a Refit:
- the engine undertray,
- the engine undertray bolts.
a Fit the max fuse box.
a Refit:
- the max fuse box bolt,
- the air filter box (see Air filter unit: Removal - Re-
fitting) (MR 415, 12A, Fuel mixture).
113918 a Connect the battery (see Battery: Removal - Refit-
ting) (MR 415, 80A, Battery).
37A-65
37A