Renault Laguna III Manual page 2435

MECHANICAL COMPONENT CONTROLS
Gear control unit: Removal - Refitting
PK4 or TL4
Tightening torquesm
gear control unit nuts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove:
- the gear lever knob, by lifting it upwards,
- the centre console (see Centre console: Removal
- Refitting) (MR 416, 57A, Interior equipment),
- the middle air distribution duct (see Rear air distri-
bution duct: Removal - Refitting) (MR 415, 61A,
Heating system).
a Cut the carpet at (1) .
a Unclip the wiring harness on the control unit at (2) .
Note:
Do not damage the control unit soundproofing.
a Remove the soundproofing (3) from the control unit.
21 Nm
a Unclip the harness at (4) .
a Remove the airbag computer cover (5) .
II - REMOVAL OPERATION FOR PART
CONCERNED
122736
a Unclip the control cables on the control unit at:
- the anchoring ball joint using an open-jawed span-
ner,
- the anchoring ball joint by pressing the button,
- the cable sleeve stops.
37A-101
37A
122734
117240