Renault Laguna III Manual page 2479

ANTI-LOCK BRAKING SYSTEM
Hydraulic brake unit: Removal - Refitting
M4R or M9R
a Remove the clips (2) from the soundproofing.
a Remove the soundproofing to access the hydraulic
unit.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the connector (3) from the hydraulic unit
computer by lifting the lug (4) .
a Remove the brake pipe unions (5) on the hydraulic
unit.
123637
a Unclip the wiring from the hydraulic unit connector at
(6) .
a Remove:
- the hydraulic unit bolts (7) on its support,
- the hydraulic unit.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the hydraulic unit,
- the brake pipe unions on the hydraulic unit.
a Tighten to torque:
- the hydraulic unit bolts on the support (8 Nm),
- the brake pipe unions on the hydraulic unit (14
Nm).
a Clip on the hydraulic unit connector wiring at (6) .
a Connect the computer connector on the hydraulic
unit.
II - FINAL OPERATION.
a Refit:
122854
- the soundproofing,
- the right-hand suspended engine mounting (see
Right-hand suspended engine mounting: Re-
moval - Refitting) (19D, Engine mounting).
38C-7
38C
123632