Renault Laguna III Manual page 2406

MECHANICAL COMPONENT CONTROLS
Manual gearbox control cable: Removal - Refitting
PK4 or TL4, and LEFT -HAND DRIVE
- the gear control unit nuts (1) (2) (3) .
a Torque tighten in order the gear control unit nuts
(21 N.m).
a Adjust the control unit (see 37A, Mechanical com-
ponent controls, Gear control unit: Adjustment,
page 37A-109) .
a Check that the system and gear selection are work-
ing correctly.
II - FINAL OPERATION.
a Refit:
- the airbag computer protector,
- the reinforcement,
- the reinforcement lower bolts,
- the reinforcement upper nuts,
- the driver's side dashboard lower trim.
a Clip:
- the wiring on the reinforcement,
- the left-hand air duct,
- the wiring on the airbag computer protector and on
the control unit.
a Refit the control unit soundproofing.
a Clip the wiring onto the control unit.
a Clip the carpet at the cutting point.
a Refit:
- the middle air distribution duct (see Rear air distri-
bution duct: Removal - Refitting) (61A, Heating
system),
- the central console (see Centre console: Remov-
al - Refitting) (57A, Interior equipment),
- the gear lever knob,
- the air filter box (see Air filter unit: Removal - Re-
fitting) (12A, Fuel mixture).
37A-72
37A