Renault Laguna III Manual page 2434

MECHANICAL COMPONENT CONTROLS
Gear control unit: Removal - Refitting
AJ0, and LEFT-HAND DRIVE
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the gear control unit nut (4) ,
- the gear control unit nuts (1) , (2) ,and (3) .
a Torque tighten in order the gear control unit nuts
(21 N.m).
a Connect the connector to the gear control unit.
a Clip:
- the wiring on the control unit,
- the gearbox control cable.
a Adjust the control unit (see 37A, Mechanical com-
ponent controls, Gear control unit: Adjustment,
page 37A-109) .
a Check that the system and gear selection are work-
ing correctly.
III - FINAL OPERATION
a Refit the airbag computer protector.
a Clip the wiring onto the airbag computer protector
and onto the reinforcement.
a Refit the control unit soundproofing.
a Clip the wiring onto the control unit.
a Clip the carpet at the cutting point.
a Place the gear selector in position R.
a Refit:
- the rear centre air duct above the soundproofing,
- the clip of the rear centre air duct above the sound-
proofing,
- the central console (see Centre console: Remov-
al - Refitting) (57A, Interior equipment),
- the gear lever knob.
a Turn the ring on the gear lever knob a sixteenth of a
turn.
122728
37A-100
37A