Renault Laguna III Manual page 2483

ANTI-LOCK BRAKING SYSTEM
Hydraulic brake unit: Removal - Refitting
K4M
Equipment required
pedal press
Tightening torquesm
hydraulic unit bolts on
the support
brake pipe unions on
the hydraulic unit
IMPORTANT
Consult the safety and cleanliness advice and oper-
ation recommendations before carrying out any
repair (see 38C, Anti-lock braking system, ABS:
Precautions for the repair, page 38C-3) .
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Position a pedal press on the brake pedal to limit
the outflow of brake fluid.
a Remove:
- the engine cover,
- the engine undertray bolts,
- the engine undertray.
8 Nm
14 Nm
a Remove the bulkhead heat shield clips (1) .
a Move the bulkhead heat shield (2) to one side.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the connector (3) from the hydraulic unit
computer by lifting the lug (4) .
a Remove the brake pipe unions (5) on the hydraulic
unit.
38C-11
38C
123637
122854