Renault Laguna III Manual page 2401

MECHANICAL COMPONENT CONTROLS
Clutch circuit: Removal - Refitting
D91, and PK4, and LEFT-HAND DRIVE
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the bleed plug (4) .
a Connect a transparent pipe to the bleed hole running
to an empty container placed under the bleed hole.
a Slightly loosen the bleed screw (5) .
a Depress the clutch pedal with your hand (to drain the
reservoir, the master cylinder and the clutch pipe).
a Remove the clip (6) from the connecting pipe be-
tween the master cylinder and the slave cylinder.
a Disconnect the clutch control pipe from the slave cyl-
inder.
a Fit blanking plugs into each opening.
a Lift the retaining clip (7) from the clutch control pipe
113919
on the master cylinder.
a Disconnect the master cylinder - slave cylinder con-
necting pipe (8) .
a Plug the openings.
a Unclip the clutch control pipe.
a Gently remove the clutch control pipe taking care not
to damage anything.
REFITTING
I - REFITTING PREPARATION OPERATION
a Check the condition of the seals.
WARNING
Do not remove the blanking plugs from each
component until the last moment.
Also, do not remove the components from their
packaging until they are to be fitted to the vehi-
cle.
II - REFITTING OPERATION FOR PART
CONCERNED
a Fit the clutch control pipe taking care not to damage
anything.
a Clip on the clutch control pipe.
a Connect the control pipe on the slave cylinder side.
37A-67
37A
113918