Renault Laguna III Manual page 2470

ELECTRONIC PARKING BRAKE
Control unit: Removal - Refitting
ELECTRONIC PARKING BRAKE
a Disconnect the control unit connector (2) .
a Unclip the control unit wiring at (3) .
a Remove the nuts (4) from the control unit.
a Push the control unit upwards.
a Remove:
- the control unit,
- the rubber mounting bushes (5) from the control
unit mounting.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the rubber mounting bushes on the control unit,
- the control unit.
a Push the control unit onto its mounting to position
the rubber mounting bushes.
a Refit the control unit nuts.
a Tighten the control unit nuts.
a Clip on the wiring of the control unit connector.
a Connect the control unit connector.
a Refit the two parking brake cables back in their
mounting.
Note:
Follow the routing noted during removal.
122698
a Refit the assisted parking brake cables at the brake
callipers.
a Check that the brake cables are correctly fitted in
their housings.
II - FINAL OPERATION
a Refit the rear wheels (see 35A, Wheels and tyres,
Wheel: Removal - Refitting, page 35A-1) .
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
a Carry out a complete check and clear any faults us-
ing the Diagnostic tool.
a Apply the after repair procedure using the Diagnos-
tic tool :
- connect the Diagnostic tool,
- select "Electronic parking brake computer",
- go to repair mode,
- display the "Before/after repair procedure" for the
computer selected,
- select "Electronic parking brake computer" in the
"List of components controlled by this computer"
section,
37B-5
37B
100240