Renault Laguna III Manual page 2436

MECHANICAL COMPONENT CONTROLS
Gear control unit: Removal - Refitting
PK4 or TL4
a Remove the gear control unit nuts (6) .
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Clip on:
- the control cable sleeve stops on the control unit,
- the anchoring ball joint using an open-jawed span-
ner on the control unit,
- the anchoring ball joint by pressing the button on
the control unit.
122735
a Refit:
- the gear control unit nut (4) ,
- the gear control unit nuts (1) (2) (3) .
a Tighten to torque and in order the gear control unit
nuts (21 Nm).
a Adjust the control unit (see 37A, Mechanical com-
ponent controls, Gear control unit: Adjustment,
page 37A-109) .
a Check that the system and gear selection are work-
ing correctly.
II - FINAL OPERATION.
a Refit the airbag computer protector.
a Clip the wiring harness onto the airbag computer
protector and onto the control unit.
a Refit the control unit soundproofing.
a Clip the wiring harness on the control unit.
a Clip the carpet at the cutting point.
a Refit:
- the middle air distribution duct (see Rear air distri-
bution duct: Removal - Refitting)
- the centre console (see Centre console: Removal
- Refitting) (MR 416, 57A, Interior equipment),
- the gear lever knob.
37A-102
37A
122735