Renault Laguna III Manual page 2407

MECHANICAL COMPONENT CONTROLS
Manual gearbox control cable: Removal - Refitting
PK4 or TL4, and RIGHT-HAND DRIVE
Tightening torquesm
gear control unit nuts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Put the gear lever in neutral.
a Remove:
- the gear lever knob, by lifting it upwards,
- the central console (see Centre console: Remov-
al - Refitting) (57A, Interior equipment),
- the middle air distribution duct (see Rear air distri-
bution duct: Removal - Refitting) (61A, Heating
system).
a Cut the carpet at (1) .
a Unclip the wiring on the control unit at (2) .
Note:
Do not damage the control unit soundproofing.
a Remove the soundproofing (3) from the control unit.
21 N.m
a Unclip the harness at (4) .
a Remove the airbag computer protector (5) .
a Unclip the left-hand air duct (6) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
122736
a Unclip the control cables on the control unit at:
- the anchoring ball joint using an open-jawed span-
ner,
- the anchoring ball joint by pressing the button,
37A-73
37A
122734
128179