Renault Laguna III Manual page 2397

MECHANICAL COMPONENT CONTROLS
Clutch circuit: Removal - Refitting
PK4
a Lift the retaining clip (5) from the clutch control pipe
on the master cylinder.
a Disconnect the master cylinder-slave cylinder con-
necting pipe (6) .
a Fit plugs into the openings.
a Gently remove the clutch control pipe taking care not
to damage anything.
REFITTING
I - REFITTING PREPARATION OPERATION
a Check the condition of the seals.
a The blanking cover caps must be removed when
connecting the adjacent parts.
II - REFITTING OPERATION FOR PART
CONCERNED
a Fit the clutch control pipe taking care not to damage
anything.
a Connect the clutch control pipe on the side of the
slave cylinder.
a Press the retaining clip of the clutch control pipe on
the master cylinder.
a Connect the clutch control pipe to the master cylin-
der.
a Refit the retaining clip of the clutch control pipe on
the master cylinder.
III - FINAL OPERATION.
a Bleed the hydraulic circuit (see 37A, Mechanical
component controls, Clutch circuit: Bleed, page
37A-47) .
LEFT-HAND DRIVE
a Refit:
- the engine undertray,
- the engine undertray bolts.
a Fit the max fuse box.
a Refit:
- the max fuse box bolt,
- the air filter box (see Air filter unit: Removal - Re-
fitting) (MR 415, 12A, Fuel mixture).
113918 a Connect the battery (see Battery: Removal - Refit-
ting) (MR 415, 80A, Battery).
37A-63
37A