Renault Laguna III Manual page 2445

MECHANICAL COMPONENT CONTROLS
Gear control unit: Adjustment
PK4 or TL4
If replaced, adjust:
- the control unit cable,
- the gearbox,
- the control unit.
Vehicle Type of Adjust-
gearbox ment
values
X91 PK4 4.5 mm
X91 TL4 4.9 mm
I - ADJUSTMENT PREPARATION STAGE
a Remove:
- the gear lever knob, by lifting it upwards,
- the central console (see Centre console: Remov-
al - Refitting) (57A, Interior equipment),
- the middle air distribution duct (see Rear air distri-
bution duct: Removal - Refitting) (61A, Heating
system).
a Cut the carpet at (1) .
a Unclip the wiring on the control unit at (2) .
Note:
Do not damage the control unit soundproofing.
a Remove the soundproofing (3) from the control unit.
Posi- Posi-
tion of tion on
lever gearbox
Neutral Neutral
Neutral Neutral
122736
37A-111
LEFT-HAND DRIVE
a Remove the air filter housing (see Air filter unit: Re-
moval - Refitting) (12A, Fuel mixture).
II - ADJUSTMENT OPERATION
a Unlock the clip (4) using a screwdriver.
Note:
The external control unit lever and the levers on
the gearbox must always be in the neutral posi-
tion.
a Check the position of the levers on the gearbox.
37A
128180