Renault Laguna III Manual page 2447

MECHANICAL COMPONENT CONTROLS
Automatic gear control cable: Removal - Refitting
AJ0, and RIGHT-HAND DRIVE
Tightening torquesm
gear control unit nuts
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Place the gear selector in position R.
a Turn the ring on the gear lever knob (1) a sixteenth
of a turn.
a Remove:
- the gear lever knob, by lifting it upwards,
- the central console (see Centre console: Remov-
al - Refitting) (57A, Interior equipment),
- the middle air duct (see Rear air distribution
duct: Removal - Refitting) (61A, Heating system).
a Place the gear selector in position D.
21 N.m
a Cut the carpet at (2) .
a Unclip the wiring on the control unit at (3) .
Note:
Do not damage the control unit soundproofing.
a Remove the soundproofing (4) from the control unit.
122726
37A-113
37A
122736