Renault Laguna III Manual page 2482

ANTI-LOCK BRAKING SYSTEM
Hydraulic brake unit: Removal - Refitting
F4R
a Remove the bulkhead lower heat shield clips (3) .
a Shift the lower heat shield backwards to access the
hydraulic unit.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the connector (4) from the hydraulic unit
computer by lifting the lug (5) .
a Remove:
- the brake pipe unions (6) on the hydraulic unit,
- the bolts (7) mounting the hydraulic unit on its sup-
port,
- the hydraulic unit.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the hydraulic unit,
- the brake pipe unions on the hydraulic unit.
a Tighten to torque:
- the hydraulic unit bolts on the support (8 Nm),
122855
- the brake pipe unions on the hydraulic unit (14
Nm).
a Connect the computer connector on the hydraulic
unit.
II - FINAL OPERATION.
a Refit:
- the bulkhead lower heat shield,
- the bulkhead lower heat shield clips,
- the catalytic converter (see Catalytic converter:
Removal - Refitting) (19B, Exhaust),
- the rear suspended engine mounting (see Lower
engine tie-bar: Removal - Refitting) (19D, En-
gine mounting),
- the engine undertray,
- the bulkhead heat shield,
- the turbocharger heat shield.
a Remove the pedal press.
122854
a Connect the battery (see Battery: Removal - Refit-
ting) (80A, Battery).
a Bleed the brake circuit (see 30A, General informa-
tion, Braking circuit: Bleed, page 30A-4) .
38C-10
38C