Show Interface Switchport Vlan Translation - Allied Telesis AT-x510-28GTX Command Reference Manual

VLAN C
OMMANDS

SHOW INTERFACE SWITCHPORT VLAN TRANSLATION

show interface switchport vlan translation
Overview Use this command to display VLAN translation information for some or all
interfaces.
show interface switchport vlan translation interface [<int>]
Syntax
Mode User Exec/Privileged Exec
Example To display VLAN translation information for port1.0.1, use the command:
awplus#
Output Figure 15-2: Example output from show interface switchport vlan translation
Table 15-1: Parameters in the output from show interface switchport vlan
Related switchport vlan translation
Commands
switchport vlan translation default drop
C613-50102-01 REV C
Parameter
interface <int>
show interface switchport vlan translation port1.0.1
port1.0.1
awplus#show interface switchport vlan translation port1.0.1

Interface: port1.0.1
VLAN on Wire VLAN
--------------- 
-------------
1649 100
default drop
translation
Parameter
Interface
VLAN on Wire
VLAN
default
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
The interface to display information about. An interface can
be a switch port (e.g. port1.0.6), a static channel group (e.g.
sa2) or a dynamic (LACP) channel group (e.g. po2).
Description
The interface on which VLAN-IDs will be translated
VLAN-ID of the packet as it will be seen on the wire
VLAN-ID of the VLAN as it was assignedwhen the VLAN
was created
The action taken on inbound tagged packets that do not
match a VLAN translation entry; either drop or accept
500