Configuring The Second Chassis - Allied Telesis SwitchBladex8112 Installation Manual

Configuring the Second Chassis

Section III: Building a Stack with VCStack Plus
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC960 Card Installation Guide
Configure the second chassis by repeating the previous procedures,
starting with "Displaying the Management Software Version Number" on
page 307. Please note the following as you configure the second unit:
 In "Displaying the Management Software Version Number" on
page 307, be sure that the management software on the switch is
version 5.4.5 or greater and that it is the same version as
management software on the first chassis.
 In "Activating the VCStack Plus Feature License" on page 309, be
sure to assign the second chassis a VCStack Plus license.

In "Activating the VCStack Plus Feature License" on page 309, be
sure to check that the second chassis has the same licenses and
features as the first chassis.

In "Setting the ID Number" on page 315, be sure to assign the
second chassis a different ID number. For instance, you should
assign the second chassis the ID number 2 if the first chassis has
the ID number 1.
After configuring the second chassis, go to "Cabling the SFP+ Slots on the
Controller Cards" on page 322.
321