Save:image[:Start] - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:SAVE:IMAGe[:STARt]

Command Syntax
:SAVE:IMAGe[:STARt] [<file_name>]
<file_name> ::= quoted ASCII string
The :SAVE:IMAGe[:STARt] command saves an image.
Be sure to set the :SAVE:IMAGe:FORMat before saving an image. If the format is NONE, the
N O T E
save image command will not succeed.
If a file extension is provided as part of a specified <file_name>, and it does not match the
N O T E
extension expected by the format specified in :SAVE:IMAGe:FORMat, the format will be
changed if the extension is a valid image file extension.
If the extension ".bmp" is used and the current :SAVE:IMAGe:FORMat is not BMP or BMP8,
N O T E
the format will be changed to BMP.
See Also •
•
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
"Introduction to :SAVE Commands"
":SAVE:IMAGe:FACTors"
":SAVE:IMAGe:FORMat"
":SAVE:IMAGe:INKSaver"
":SAVE:IMAGe:PALette"
":SAVE:FILename" on page 626
on page 623
on page 628
on page 629
on page 630
on page 631
27
:SAVE Commands
627