Power:transient:exit - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:POWer:TRANsient:EXIT

Command Syntax
:POWer:TRANsient:EXIT
The :POWer:TRANsient:EXIT command exits (stops) the transient analysis.
This command is equivalent to pressing the Exit softkey on the oscilloscope
front panel during the analysis.
See Also •
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
":POWer:TRANsient:APPLy"
":POWer:TRANsient:IINitial"
":POWer:TRANsient:INEW"
":POWer:TRANsient:NEXT"
on page 608
on page 610
on page 611
on page 612
25
:POWer Commands
609