Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 433

:MEASure:DUAL:VAMPlitude
Overview
This measurement is available with the N2820A high sensitivity current
probe when both the Primary and Secondary probe cables are used. This
measurement joins the Zoom In waveform data below the probe's clamp
level with Zoom Out waveform data above the probe's clamp level to create
the waveform on which the measurement is made.
Command Syntax
:MEASure:DUAL:VAMPlitude [<source1>][,<source2>]
<source1>,<source2> ::= CHANnel<n> with N2820A probe connected
<n> ::= 1 to (# analog channels) in NR1 format
The :MEASure:DUAL:VAMPlitude command installs a screen measurement
and starts a vertical amplitude measurement.
If the optional source parameter(s) are specified, the currently specified
source(s) are modified.
Query Syntax
:MEASure:DUAL:VAMPlitude? [<source1>][,<source2>]
The :MEASure:DUAL:VAMPlitude? query measures and returns the vertical
amplitude of the waveform. To determine the amplitude, the instrument
measures Vtop and Vbase, then calculates the amplitude as follows:
Return Format
<value><NL>
<value> ::= the amplitude of the selected waveform in NR3 format
See Also
•
•
•
•
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
vertical amplitude = Vtop - Vbase
":MEASure:DUAL:CHARge"
":MEASure:DUAL:VAVerage"
":MEASure:DUAL:VBASe"
":MEASure:DUAL:VPP"
":MEASure:DUAL:VRMS"
"Introduction to :MEASure Commands"
":MEASure:SOURce"
":MEASure:VTOP" on page 480
on page 432
on page 434
on page 435
on page 436
on page 437
on page 420
on page 458
21
:MEASure Commands
433