Trigger:zone:state - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

32
:TRIGger Commands

:TRIGger:ZONE:STATe

Command Syntax
:TRIGger:ZONE:STATe <on_off>
<on_off> ::= {{0 | OFF} | {1 | ON}}
The :TRIGger:ZONE:STATe command enables or disables the zone qualified
trigger feature.
When the zone qualified trigger is on, the zone(s) are actively being used
to qualify the trigger.
Note that the :TRIGger:ZONE<n>:STATe setting must also be ON for a zone
to be active.
Note that :TRIGger:ZONE:STATe mimics the behavior of the [Zone] key on
the front panel, and :TRIGger:ZONE<n>:STATe mimics the behavior of the
Zone 1 On and Zone 2 On softkeys. At least one zone's state must be on for
the Zone Trigger feature (:TRIGger:ZONE:STATe) to be on. When the states
of both individual zones are turned off, Zone Trigger is automatically
turned off. In this case, when Zone Trigger is turned back on Zone 1 is
forced to on. Otherwise, if at least one zone was on when Zone Trigger
was turned off, the same configuration of individual zone on/off states will
be restored when Zone Trigger is turned back on.
Query Syntax
:TRIGger:ZONE:STATe?
The :TRIGger:ZONE:STATe? query returns whether the zone qualified
trigger feature is enabled or disabled.
Return Format
<on_off><NL>
<on_off> ::= {0 | 1}
See Also •
•
1014
(see page 1208)
":TRIGger:ZONE<n>:STATe"
":TRIGger:ZONE:SOURce"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 1018
on page 1013