Measure:cploss - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:MEASure:CPLoss

Command Syntax
:MEASure:CPLoss [<source1>][,<source2>]
<source1> ::= {FUNCtion<m> | MATH<m>}
<source2> ::= {CHANnel<n>}
<m> ::= 1-4 in NR1 format
<n> ::= 1 to (# analog channels) in NR1 format
The :MEASure:CPLoss command installs a power loss per cycle
measurement on screen.
The <source1> parameter is typically a math multiply waveform or other
waveform that represents power (voltage * current). This source can also
be specified by the :MEASure:SOURce command.
Power loss per cycle is Pn = (Vdsn * Idn ) * ( Time range of zoom
window) * ( Counter measurement of the voltage of the switching signal),
where n is each sample.
This measurement operates when in zoom mode and the counter
measurement is installed on the voltage of the switching signal.
Query Syntax
:MEASure:CPLoss? [<source1>][,<source2>]
The :MEASure:CPLoss query returns the switching loss per cycle in watts.
Return Format
<return_value><NL>
<return_value> ::= the switching loss per cycle value in NR3 format
See Also •
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
":MEASure:SOURce"
":POWer:SWITch:APPLy"
on page 458
on page 602
:MEASure Power Commands
22
491