Sbus<N>:Uart:source:tx - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

28
:SBUS<n> Commands
:SBUS<n>:UART:SOURce:TX
Command Syntax
:SBUS<n>:UART:SOURce:TX <source>
<source> ::= {CHANnel<n> | EXTernal} for the DSO models
<source> ::= {CHANnel<n> | DIGital<d>} for the MSO models
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
The :SBUS<n>:UART:SOURce:TX command controls which signal is used as
the Tx source by the serial decoder and/or trigger when in UART mode.
Query Syntax
:SBUS<n>:UART:SOURce:TX?
The :SBUS<n>:UART:SOURce:TX? query returns the current source for the
UART Tx signal.
Return Format
<source><NL>
See Also •
•
•
•
784
(see page 1208)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 944
":SBUS<n>:UART:TRIGger:TYPE"
":SBUS<n>:UART:BITorder"
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 935
on page 790
on page 775