Wgen<W>:Voltage:offset - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:WGEN<w>:VOLTage:OFFSet
Command Syntax
:WGEN<w>:VOLTage:OFFSet <offset>
<w> ::= 1 or 2 in NR1 format
<offset> ::= offset in volts in NR3 format
The :WGEN<w>:VOLTage:OFFSet command specifies the waveform's offset
voltage or the DC level. Use the :WGEN<w>:VOLTage command to specify
the amplitude.
You can also specify the amplitude and offset indirectly using the
:WGEN<w>:VOLTage:HIGH and :WGEN<w>:VOLTage:LOW commands. For
example, an amplitude of 5 V and an offset of 1 V is the same as a
high- level voltage of 4 V and a low- level voltage of - 1 V.
Query Syntax
:WGEN<w>:VOLTage:OFFSet?
The :WGEN<w>:VOLTage:OFFSet? query returns the currently specified
waveform offset voltage.
Return Format
<offset><NL>
<offset> ::= offset in volts in NR3 format
See Also •
•
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
"Introduction to :WGEN<w> Commands"
":WGEN<w>:FUNCtion"
":WGEN<w>:VOLTage"
":WGEN<w>:VOLTage:HIGH"
":WGEN<w>:VOLTage:LOW"
on page 1058
on page 1067
on page 1094
on page 1095
on page 1096
:WGEN<w> Commands
1097
34