Trigger:eburst:count - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

:TRIGger:EBURst:COUNt

Command Syntax
:TRIGger:EBURst:COUNt <count>
<count> ::= integer in NR1 format
The :TRIGger:EBURst:COUNt command sets the Nth edge at burst counter
resource. The edge counter is used in the trigger stage to determine which
edge in a burst will generate a trigger.
Query Syntax
:TRIGger:EBURst:COUNt?
The :TRIGger:EBURst:COUNt? query returns the current Nth edge of burst
edge counter setting.
Return Format
<count><NL>
<count> ::= integer in NR1 format
See Also
•
•
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
"Introduction to :TRIGger Commands"
":TRIGger:EBURst:SLOPe"
":TRIGger:EBURst:IDLE"
on page 935
on page 957
on page 956
32
:TRIGger Commands
955