Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 179

*SAV (Save)
Command Syntax
*SAV <value>
<value> ::= {0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9}
The *SAV command stores the current state of the instrument in a save
register. The data parameter specifies the register where the data will be
saved.
See Also •
•
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1208)
"Introduction to Common (*) Commands"
"*RCL (Recall)" on page 175
Common (*) Commands
on page 164
5
179