Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual page 614

26
:RECall Commands
Table 101 :RECall Commands Summary (continued)
Command
:RECall:SETup[:STARt]
[<file_spec>] (see
page 619)
:RECall:WMEMory<r>[:S
TARt] [<file_name>]
(see page 620)
Introduction to
The :RECall subsystem provides commands to recall previously saved
:RECall oscilloscope setups, reference waveforms, and masks.
Commands
Reporting the Setup
Use :RECall? to query setup information for the RECall subsystem.
Return Format
The following is a sample response from the :RECall? query. In this case,
the query was issued following the *RST command.
:REC:FIL "scope_0"
614
Query
n/a
n/a
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
Options and Query Returns
<file_spec> ::= {<internal_loc>
| <file_name>}
<internal_loc> ::= 0-9; an
integer in NR1 format
<file_name> ::= quoted ASCII
string
<r> ::= 1 to (# ref waveforms) in
NR1 format
<file_name> ::= quoted ASCII
string
If extension included in file
name, it must be ".h5".